Technical Articles
Selection guides, maintenance notes and application stories
Solenoid Dosing Pump Operation: Keypad, Display and Modes
A hands-on guide to solenoid dosing pump operation using ProMinent gamma/X: keypad and display, manual settings, contact and batch modes, level and pressure alarms.
Plunger Pump Installation: Location, Base and Leakage Control
A practical plunger pump installation guide for metering duty: where to place the pump, how to build the base, pipe the suction and discharge, and handle packing leakage.
Polymer Dosing System Installation: Water, Powder and Start-Up
A practical polymer dosing system installation guide: base and layout, raw water pressure, powder feeder placement, pump suction, wiring and clean-water start-up.
Metering Pump Installation Requirements: Base, Piping, Valves, Power
Metering pump installation rules in five parts: base, suction piping, discharge piping, valve order and electrical work, written as clauses for a spec or a checklist.
How to Read a Metering Pump Installation Drawing and Its Details
How to read a metering pump installation drawing and its detail sheets: the four key nodes, scale and material notes, site checks before work, and common mistakes.
Metering Pump Stroke Setting at First Startup: Where to Start
Where to put the metering pump stroke setting at first startup: prime at full stroke, calculate a starting value from target and rated flow, then calibrate and trim.
Hydraulic Diaphragm Pump Operation: Oil Filling to Commissioning
A practical guide to hydraulic diaphragm pump operation: oil filling, venting the hydraulic chamber, priming, zero-stroke start, stroke ramp-up and calibration.
Chemical Tank Vent Line: Sizing, Routing and Fume Control
A chemical tank vent lets a dosing tank breathe as the pump draws down and it refills. Learn how to size and route the line, where to end it and how to treat fumes.
Metering Pump VFD Settings: Drive Parameters for Dosing Pumps
Metering pump VFD settings explained in commissioning order: motor nameplate data, min and max frequency, ramps, constant torque V/f, 4-20 mA scaling, fault relays.
Chemical Injection Point Design: How to Tie a Dosing Line In
How to build a chemical injection point on a main water pipe: tee, saddle or weld-o-let, pipe orientation, quill depth, valve order, materials and mixing distance.
245 items · Page 11 of 25