Technical Articles
Selection guides, maintenance notes and application stories
Vibrating Fork Level Switch: Overfill and Pump Dry Run Protection
How a vibrating fork level switch protects chemical tanks and dosing pumps: MIN vs MAX mode, fork orientation, buildup and foam, and interlock delays for pumps and PLCs.
Pressure Switch for Metering Pump Protection: High and Low Cutoff
How to use a pressure switch for metering pump protection: where to mount it, high and low cutoff set points, deadband, snubbers and how it differs from a relief valve.
Conductive Level Switch: How It Works, Relay Wiring and Setpoints
How a conductive level switch and electrode level relay control pumps: probe layout, relay wiring, high and low setpoints, conductivity limits and fouling faults.
Water Quality Data Logger: Getting Analyzer Data to the Platform
How a water quality data logger collects analog and Modbus readings, uploads over 4G or wired links, back-fills data after outages, and flags maintenance periods.
Transmitter Range Setting: Zero Suppression, Elevation, Turndown
A field guide to transmitter range setting for level and DP service: when to use zero suppression or elevation, how turndown ratio affects accuracy, and how to verify.
Thermal Mass Flow Meter for Low Gas Flows: Air, CO2 and Biogas
How a thermal mass flow meter handles low-flow gas: the thermal dispersion principle, gas composition and moisture effects, insertion vs inline, and installation tips.
TSS Sensor Placement and Range: Influent, Clarifier and Outfall
How to choose the range and mounting point for an online TSS sensor, correlate it with lab gravimetric results, and avoid bubbles, wall reflection and sediment.
Silica Analyzer for Boiler Feedwater: Sample Points and Readings
How an online silica analyzer protects boilers and turbines: where to install it, how the molybdenum blue method works, and what rising silica readings mean.
Open Channel Flow Meter Guide: Parshall Flumes, Weirs and Level
How an open channel flow meter turns head into flow: choosing a Parshall flume, V-notch or rectangular weir, mounting radar or ultrasonic sensors, avoiding silt and ice.
Instrument Surge Protection and Grounding for Field Transmitters
Practical instrument surge protection: where to fit 4-20mA and power surge protectors, why signal grounds use one point, which cable shield end to ground, and bonding.
245 items · Page 1 of 25