Technical Articles
Selection guides, maintenance notes and application stories
Parallel Metering Pumps on One Discharge Header: What to Watch
Parallel metering pumps on one header can push against each other if check valves and isolation are sloppy. This note covers two pumps running at once, not duty-standby.
Outdoor Metering Pump Installation: Rain Covers and Sunshades
Outdoor metering pump installation needs a sunshade, a rain cover, sealed cable glands and a drained pad so the terminal box and plastic head stay dry.
Closed Loop Metering Pump Control with a Discharge Flow Meter
A closed loop metering pump uses a discharge flow meter to correct stroke or frequency. Where to fit the meter, how to calibrate, and what to do when the signal fails.
How to Use a Batch Dosing Pump for a Fixed Volume
A batch dosing pump delivers a set volume each cycle, for intermittent reactions and shock doses. See batch mode, stroke counts, and what to do if power fails mid-batch.
How to Read Metering Pump Accuracy: Steady State and Repeatability
Metering pump accuracy on a datasheet is usually steady-state error and repeatability under stated stroke, pressure and fluid. Write those test conditions into the order.
Acceleration Loss in a Metering Pump on Long Suction Lines
Acceleration loss in a metering pump appears on a long, small-bore suction line. Shorten the pipe, enlarge the bore, or add a suction stabilizer before the pump starves.
Lime Slurry Dosing System Design: Loops, Pumps and Flushing
How to design a lime slurry dosing system that does not clog: tank agitation, a recirculation loop with short take-offs, line sizing, pump choice and flushing water.
How to Read a Chemical SDS Before You Start a Dosing Task
A chemical SDS, often still called an MSDS on site, should be read before dosing for hazards, PPE, incompatibles, spills and first aid, not replaced by guessed data.
Ferrous Sulfate Dosing: Preventing Oxidation, Crystals and Clogging
Ferrous sulfate dosing fails mostly through oxidation and crystallization. How to set solution strength, lay out the tanks, flush the line and choose pump materials.
How to Build a Remote Monitoring Dosing System: Points and Failover
A remote monitoring dosing system must define the points to collect, who may change setpoints, and what happens if the link drops, written before the screen goes live.
245 items · Page 3 of 25