Zhejiang Weilan Technology Co., Ltd.

Maintenance

Selection guides, maintenance notes and application stories

Maintenance

Metering Pump Bypass Valve and Return Line: What Each One Does

What a metering pump bypass valve and a return line valve do: priming, calibration, depressurizing before service, standby switching, and the mistakes that cut dosing.

Maintenance

Duty Standby Dosing Pumps: Changeover Procedure Without Gaps

A step-by-step pump changeover procedure for duty standby dosing pumps: prime the standby, match stroke, confirm flow, then stop the duty pump. Plus auto switchover.

Maintenance

Wastewater Dosing System Fault Finding: Problems and Check Order

A wastewater dosing system fault is rarely just the pump. Check make-up, tank, piping, pump, injection point and control signals in order, with chemical-specific tips.

Maintenance

Metering Pump Coupling Alignment: Gearbox to Motor Guide

Metering pump coupling alignment explained: flange-mounted vs coupled motors, step-by-step motor removal, checking radial and angular offset, and soft foot.

Maintenance

Plunger Pump Bearing Failure: Lubrication, Alignment and Load

Plunger pump bearing failure usually traces back to oil, motor alignment or sustained overpressure. Learn the warning signs, root-cause checks and repair tips.

Maintenance

Plunger Metering Pump Noise: Gearbox, Plunger and Valve Checks

Diagnose plunger metering pump noise by source: gearbox bearings and worm gear, plunger and packing, or check valves and piping. Includes a field checklist.

Maintenance

Metering Pump Relief Valve Damage: Causes and Prevention

Why a metering pump relief valve fails on mechanical diaphragm pumps: chattering, crystal build-up, wrong set pressure and bad piping, plus a field check routine.

Maintenance

Hydraulic Diaphragm Pump Installation: Base, Piping and Oil

Hydraulic diaphragm pump installation in five steps: a level base, clean suction piping, protected discharge, the right hydraulic oil and a pre-start checklist.

Maintenance

Pump Head Won't Close After Diaphragm Replacement: What to Check

Pump head won't close after diaphragm replacement? Check diaphragm position, backplate orientation, stroke setting and bolt sequence, then fix leaks and recalibrate.

Maintenance

Boiler Dosing System Faults: Common Problems and Check Order

Boiler dosing faults show up fast in water chemistry. Check tank, pump, high-pressure line, check valve, injection point and controls in order, with chemical tips.

110 items · Page 4 of 11