FAQ
Selection guides, maintenance notes and application stories
Milton Roy Spare Parts: How to Find the Right Part Number
Finding Milton Roy spare parts starts at the nameplate. Learn what to copy, how IOM parts tables work, why location numbers differ from part numbers, and what to order.
Milton Roy Pneumatic Stroke Control: How It Works and Fails Safe
How Milton Roy pneumatic stroke control works on Milroyal B pumps: 3-15 psi signal, 80-100 psi supply air, failure actions, field retrofit steps and when to go electric.
Dosing Pump Test Report: What to Check Before You Accept the Pump
How to read a dosing pump test report: factory acceptance test data, type test scope, third-party inspection, material certificates and red flags buyers miss.
Metering Pump vs Transfer Pump: Which One Your Process Needs
Metering pump vs transfer pump: one moves volume, the other doses a set amount against changing pressure. How to tell them apart and when a dosing pump is required.
Metering Pump Low Flow: Why Stroke Adjustment Has No Effect
Metering pump low flow even at 100% stroke and full speed? Check the control mode, the rated test conditions, back pressure, viscosity, gas and check valves in order.
Dead Heading a Plunger Pump: Damage, Causes and Protection
What happens when dead heading a plunger pump against a closed discharge valve, how to spot it on site, and which relief valve and interlocks protect it.
Metering Pump Stuck? Isolate Power First, Then Troubleshoot
Metering pump stuck? What to do: three safe first steps, how motor and solenoid pumps fail differently, common causes like blocked discharge and crystals.
Metering Pump Slow Priming After a Stop: Finding the Backflow
Why a metering pump takes minutes to deliver chemical after a stop, how to confirm suction line backflow, check the foot valve and joints, and fix slow priming for good.
Metering Pump Pressure Gauge: Normal Readings and Warning Signs
How to read a metering pump pressure gauge: why the needle swings, what normal looks like, what high, low, wide or zero readings mean, and how to pick the gauge.
Hydraulic Diaphragm Pump Relief Valve Keeps Lifting: Causes
Why a hydraulic diaphragm pump relief valve keeps lifting: discharge blockage, low set point, worn seats or bad oil, plus a safe order to check and reset it.
84 items · Page 2 of 9