Zhejiang Weilan Technology Co., Ltd.

FAQ

Selection guides, maintenance notes and application stories

FAQ

Dosing Pump Low Output: Troubleshoot from Suction to Discharge

Fix dosing pump low output step by step: suction lift, strainers, air leaks, check valve deposits, worn diaphragms, back pressure, siphoning, stroke and calibration.

FAQ

Cheonsei Pump Error Codes: Alarm Lights and Fault Tables by Model

Cheonsei pump error codes by series: KD mechanical pumps use a fault table, SP-A uses LED colors, SP-C flags low level and signal errors. Unlisted codes: see the manual.

FAQ

PAC Dosing System Troubleshooting: Tank, Mixer, Level, Pump, Line

PAC dosing system troubleshooting zone by zone: tank and solution strength, mixer trips, false level alarms, pump not delivering, and line blockage or leaks.

FAQ

Iwaki Pump Error Codes: EHN Display Messages, Alarms and Resets

Iwaki pump error codes explained for EHN solenoid pumps: what STOP, -STOP, OVER, keypad lock and FCM alarms mean, what usually causes them and how to reset.

FAQ

Hydraulic Diaphragm Pump Dry Running: What Happens and How to Stop It

Hydraulic diaphragm pump dry running overfills the oil chamber through the make-up valve and overstretches the diaphragm. Learn the warning signs and interlocks.

FAQ

Dosing Pump Low Pressure: 6 Causes and the Order to Check Them

Dosing pump low pressure usually comes from the back pressure valve, relief valve, leaking check valves, gas lock, diaphragm damage or line leaks. Check in this order.

FAQ

SEKO Pump Alarm Codes: Lev, Flw, Mem and Parameter Error Explained

SEKO pump alarm codes on the Tekna EVO TPG are short: Lev for level, Flw for flow, Mem for pulse memory and Parameter Error for an internal fault. Learn what each means, how to clear it and how to set the alarm menu.

FAQ

Iwaki Pump Stop Mode: Why an EHN Pump Stops and How to Release It

Iwaki pump stop mode explained for EHN pumps: keypad stop and key lock, the external STOP contact and level sensors, EXT mode with no pulses, and FCM alarm stops on EHN-YN, with the order to check them on site.

FAQ

Metering Pump Water Hammer: Why the Pipework Knocks and How to Stop It

Metering pump water hammer makes discharge lines bang in time with every stroke. See why pulsating flow, long thin lines, low back pressure and loose supports cause it, and how dampeners, back pressure valves and clamps fix it.

FAQ

Solenoid Dosing Pump Not Priming? Bleed the Head, Check the Valves, Mind the Lift

A solenoid dosing pump not priming usually has air trapped in the head, a stuck or reversed check valve ball, or too much suction lift with a leaking suction line. Here is how to read the symptoms and fix each one on site.

84 items · Page 4 of 9