Zhejiang Weilan Technology Co., Ltd.

FAQ

Selection guides, maintenance notes and application stories

FAQ

Dosing Pump Not Pumping but the Suction Line Stays Full? Here Is Why

Dosing pump not pumping, yet the liquid in the suction tube does not drop back? That points to the pump head or discharge side. A step-by-step check of stroke, diaphragm, check valves, back pressure valve, blocked outlet and gas lock.

FAQ

Sodium Hypochlorite Dosing Pump Gas Lock Troubleshooting and High-Viscosity PAM Polymer Feed

Struggling with vapor-locked bleach pumps or clogged PAM flocculant lines? Master sodium hypochlorite dosing pump gas lock troubleshooting, auto-degassing head upgrades, injection quill descaling, and spring-loaded check valve selection for viscous PAM polymer dosing.

FAQ

Metering Pump Stroke Adjustment: Clockwise or Counterclockwise?

Metering pump stroke adjustment has no industry-wide rule for which way increases flow. Brands differ and mounting orientation can flip it, so follow the scale marking and the manual. Learn a three-step check, lock screw and motor rotation mix-ups, and how to verify.

FAQ

Dosing Pump Price: Why Quotes for the Same Flow Rate Differ So Much

Dosing pump price gaps between suppliers usually come from different pressure margins, drive types, wetted materials, controls, accessories and service scope. Learn how to line up quotes item by item and what to ask before you buy.

FAQ

Steam Boiler Chemicals: What to Dose by Boiler Size and Pressure

Which steam boiler chemicals you need depends on boiler pressure, makeup water treatment and whether there is a deaerator. Small low-pressure boilers often use blended scale inhibitors, sulfite and caustic; medium-pressure units dose phosphate, scavenger and ammonia separately. Here is how to choose and how the dosing skid changes.

FAQ

Chemical Dosing Tank Mixer for PAC: Does the Solution Need Constant Stirring?

A chemical dosing tank mixer is needed to dissolve PAC, but once the batch is fully dissolved it can usually stop. Learn when intermittent mixing makes sense, how to set mixing time, how to choose mixer material, speed and impeller, and the problems caused by running the mixer all day.

FAQ

PAC Dosage for Sewage: Finding the Right Dose With a Jar Test

PAC dosage for sewage has no universal figure. It depends on whether you are removing phosphorus, polishing secondary effluent or handling an upset, and it is set with a jar test. Learn how to convert mg/L into grams per cubic meter and pump flow, what changes the dose and how to spot under and overdosing.

FAQ

Dosing Pump Not Responding to Control? Boiler Pump Signal and Hand-Auto Checks

A dosing pump not responding to DCS or PLC commands is rarely a failed pump. Most cases trace back to the hand-off-auto switch, an active interlock, the pump's control mode, 4–20 mA or pulse wiring, or VFD settings. Here is a troubleshooting order from panel to pump, plus what to specify at purchase.

FAQ

Dosing Pump Injection Valve: What It Does and What Happens Without One

A dosing pump injection valve is a spring-loaded check valve at the injection point. It stops process water backflow, limits siphoning and over-feed, delivers chemical into the flow, and adds opening pressure at the pump outlet. Learn when it is required, what fails without it, and the common faults.

FAQ

Metering Pump Motor Rotation: Does Direction Matter on a Diaphragm Pump?

Metering pump motor rotation has one correct direction, marked by the arrow on the motor or pump. Reverse rotation may still pump, but manuals warn it can damage the drive. Learn how to bump-test, fix three-phase and single-phase wiring, and check gearbox oil.

84 items · Page 5 of 9