Welloff Solenoid Metering Pumps: WS Manual, WP Pulse, WM 4-20mA & WD RS485 Guide
Welloff solenoid diaphragm metering pumps are popular among dosing skid integrators for their clear control-option suffixes. Based on our WS, WP, WM, and WD pages, here is how each model maps to your automation architecture.
1. Control Suffixes Explained
- Welloff WS (Manual): Simple local frequency adjustment for steady chemical feed.
- Welloff WP (Pulse): Paces pump strokes against water-meter pulses for flow-proportional dosing.
- Welloff WM (4–20 mA): Accepts
4–20 mAanalog signals from pH/ORP/chlorine analyzers or PLCs. - Welloff WD (RS485 Modbus): Integrates directly into SCADA, HMIs, and IoT water platforms via RS485.
2. Wiring & Commissioning Tips
Keep 4–20 mA and RS485 cables shielded and separated from VFD power lines. For RS485 multi-drop networks, assign each Welloff pump a unique Slave ID and matching baud rate. Always pair with a backpressure valve for repeatable proportional dosing.
Conclusion
Match WS for manual, WP for pulse, WM for 4–20 mA, and WD for RS485 Modbus control. Contact our team for Modbus register maps and quotes.
FAQ
Can the WM (4–20 mA) model be switched to manual mode for priming?
Yes, you can switch to manual mode on the keypad for priming or maintenance, then return to 4–20 mA auto mode.
Can the WD RS485 port connect directly to an HMI?
Yes, any HMI supporting Modbus RTU master can read/write start, stop, and frequency over the A/B terminals.
Does WP accept dry-contact water-meter pulses?
Yes—just verify the pulse input setting matches your flowmeter's dry-contact or open-collector output.
Is it normal for the solenoid housing to feel warm during 24/7 duty?
Moderate warmth is normal; ensure rated backpressure isn't exceeded and ambient ventilation is adequate.
Do you supply all Welloff control variants?
Yes, Weilan supplies WS, WP, WM, and WD models with full technical support.