Zhejiang Weilan Technology Co., Ltd.

Technical Articles

Selection guides, maintenance notes and application stories

Technical Articles

How a Hydraulic Diaphragm Metering Pump Works: Oil, Diaphragm and the Three Internal Valves

How a hydraulic diaphragm metering pump works: a plunger pushes hydraulic oil, and the oil moves the diaphragm with balanced pressure on both sides. Learn what the refill, relief and air bleed valves do, why the design handles high pressure, and what to watch on site.

Technical Articles

How an Automatic Chemical Dosing System Works: Level Interlocks and Auto Batching

An automatic chemical dosing system runs on two pieces of logic: level interlocks that protect the pump and mixer, and an auto-batching cycle that refills, doses and mixes the solution tank. See what each level point does and how to commission it.

Technical Articles

Dosing Tank Piping: How to Connect Make-up Water, Pump Suction, Overflow and Drain

Dosing tank piping comes down to five connections: make-up water inlet, pump suction outlet, overflow, drain and relief valve return. Where each one goes, which valves it needs, and the site mistakes that cause backflow, sludge in the pump and overflowing tanks.

Technical Articles

How a Chemical Dosing System Works: Tank, Mixer, Metering Pump and Controls

How a chemical dosing system works, followed stage by stage: solution make-up in the tank, mixing, metering by stroke length and frequency, discharge valves that hold pressure, and the control panel that ties it together.

Technical Articles

How to Read a Dosing System P&ID: Lines, Valves and Instrument Symbols

A practical guide to reading a dosing system P&ID: start with the legend, follow the chemical from tank to injection point, then decode instrument tags and signal lines. Covers valve symbols, LT, LS and PI tags, and the details reviewers most often miss.

Technical Articles

Diaphragm Metering Pump Parts and Their Functions: Pump Head, Diaphragm and Check Valves

Diaphragm metering pump parts explained by liquid end and drive end: pump head, diaphragm, suction and discharge check valves and degassing valve, then motor, gearbox, eccentric, push rod and stroke adjuster. What each part does, common materials and failure signs.

Technical Articles

Cooling Tower Chemical Treatment: How Scale Inhibitors, Corrosion Inhibitors and Biocides Work

Cooling tower chemical treatment controls three problems: scale, corrosion and biofouling. Learn how each chemical works, which ones to feed continuously or as a slug dose, where to inject them, and how to set up the dosing pumps.

Technical Articles

How a Urea Dosing System Works: Metering, Dilution and Injection

A urea dosing system for SCR or SNCR meters concentrated urea, blends it with dilution water and splits it to atomizing lances. See how each module works and where designs usually go wrong.

Technical Articles

Urea Injection Control: Load Following and Pump Speed Adjustment

Good urea injection control uses a VFD-driven metering pump, load feedforward and slow NOx feedback. Learn how to split stroke and speed, handle analyzer lag and avoid low-load errors.

Technical Articles

Chlorine Dosing System Diagram: From Hypochlorite Tank to Injection Point

How to read a chlorine dosing system diagram for sodium hypochlorite: storage tank, suction line, metering pump, relief and back pressure valves, injection quill and control signals, plus the details that often get missed.

245 items · Page 20 of 25