NETZSCH NEMO C.Pro Dosing Pump: Specs, Rotation Check & Selection Guide
When dosing viscous polymers (PAM), shear-sensitive fluids, or off-gassing chemicals, NETZSCH progressive cavity pumps (NEMO series) deliver smooth, pulsation-free flow where diaphragm pumps struggle. Based on our NEMO C.Pro product page, this guide covers specs, rotation checks, and selection essentials.
1. Key Series Specifications
- NETZSCH NEMO C.Pro: All-synthetic (
PP/PVDF) corrosion-resistant dosing pump covering0.05–1.5 m³/h(50–1,500 L/h), up to20 bar, and viscosities up to 20,000 mPas with flow proportional to speed. - NETZSCH PERIPRO Chemical: Heavy-duty peristaltic hose pump (
0.18–39 m³/h,10 bar,<1%deviation) for abrasive or crystallizing chemicals.
2. How to Verify Rotation Direction Safely
Never run a progressive cavity pump dry or in the wrong direction for extended periods:
- Check the Direction Arrow: Verify the rotation arrow stamped on the pump housing/drive lantern.
- Wet Before Jogging: Fill the pump chamber with water or process fluid first to lubricate the elastomer stator, then jog the motor briefly (<1 second) to confirm shaft rotation matches the arrow.
- Swap Phases if Reversed: If running backward, swap any two phases on a 3-phase motor. Running in reverse can unthread internal joint components or overload the shaft seal.
3. Four Selection Checks
- Viscosity & Speed: Derate pump RPM as viscosity climbs to minimize stator wear.
- Elastomer Compatibility: Match stator material (
NBR,EPDM,FPM) to your exact chemical and temperature. - Dry-Run Protection: Install a dry-run temperature/flow switch on the stator housing—dry running destroys elastomers in seconds.
- VFD Control: Pair with a frequency inverter for linear, pulsation-free flow modulation.
Conclusion
Verifying NETZSCH rotation direction wet-primed and matching elastomer/speed to viscosity ensures long stator life. For sizing or genuine spare stators/rotors, contact our team.
FAQ
Why choose NEMO C.Pro over a diaphragm metering pump?
C.Pro provides continuous, pulsation-free dosing without dampeners and handles viscosities up to 20,000 mPas effortlessly.
Why can't a NETZSCH progressive cavity pump be jogged dry?
The rotor and rubber stator form an interference fit lubricated solely by the pumped liquid; dry friction overheats and damages the stator rapidly.
Can the pump be run in reverse to drain piping?
Only briefly on approved configurations—reverse operation places discharge pressure on the mechanical seal and risks loosening threaded joints.
How often should the rubber stator be replaced?
Typically every 1–2+ years on clean chemical dosing, or sooner on abrasive slurries when discharge flow drops.
Do you supply genuine NETZSCH stators, rotors, and seals?
Yes, Weilan supplies complete NETZSCH pumps and original spare parts.