Technical Articles
Selection guides, maintenance notes and application stories
Metering Pump Pressure: How to Set the Back Pressure and Relief Valves
A metering pump does not set its own pressure. Learn how the back pressure valve builds metering pump pressure, how the relief valve caps it, which to set first, and why a diaphragm pump shows low pressure.
Metering Pump Installation Diagram: Suction and Discharge Accessories in the Right Order
How to read a metering pump installation diagram: follow the flow from tank to injection point, and learn why the relief valve, pulsation dampener, back pressure valve and calibration column sit where they do.
Metering Pump 4-20mA vs Pulse Control: Choosing the Right Signal
Metering pump 4-20mA control suits analyzer-based dosing, while pulse input suits flow-paced dosing. How to wire each, scale the signal, set multiply or divide, and avoid the common wiring mistakes.
Dosing System Piping: Reading the Four Lines on a Skid Drawing
Dosing system piping comes down to four lines: water inlet, chemical discharge, overflow and drain. Where each connects, which valves belong on it, common installation mistakes and a water test checklist.
How to Adjust Dosing Pump Dose Rate: Calculate, Set, Then Calibrate
Adjusting a dosing pump dose rate in three steps: work out the target flow from water flow and chemical strength, set stroke length and frequency, then confirm with a drawdown test before you trust the dial.
Metering Pump Stroke Length: Why Staying Above ~30% Matters
Metering pump stroke length should usually stay out of the bottom of the dial. See why long life below about 30% hurts linearity, how frequency should carry turndown, and when to pick a smaller pump instead.
Metering Pump Pulsation Dampener: Principle and When to Use One
A metering pump pulsation dampener uses a precharged bladder to cut discharge pulse peaks. See why long thin lines need one, how it works with back pressure valves, and what fails if you skip it.
Metering Pump Back Pressure Valve Purpose: Anti-Siphon and Stable Accuracy
The main purpose of a metering pump back pressure valve is to create steady discharge pressure so check valves seat cleanly and siphoning stops. Learn when you need one, how to set it, and what fails if you skip it.
Dosing Pump Back Pressure Valve vs Relief Valve: Where Each One Goes
A dosing pump back pressure valve holds stable discharge pressure and limits siphoning; a relief valve protects against overpressure. Learn the difference, mounting points, setpoints and what goes wrong when the two are swapped.
Chinese Metering Pump vs Imported Brands: Real Gaps in Accuracy and Service Life
Is a Chinese metering pump as accurate and durable as an imported one? Published accuracy, turndown and diaphragm life data show where the gap is real.
245 items · Page 22 of 25