Zhejiang Weilan Technology Co., Ltd.

Maintenance

Selection guides, maintenance notes and application stories

Maintenance

Online pH ORP Conductivity Analyzer Calibration and Electrode Maintenance Guide

When an automated dosing loop overdoses acid, alkali, or sodium hypochlorite, electrode drift or junction fouling is usually to blame. Learn step-by-step online pH ORP conductivity analyzer calibration, chemical cleaning for industrial probes, and bypass flow cell vs immersion mounting.

Maintenance

Doseuro Metering Pump Troubleshooting and Installation Guide

Complete field guide to Doseuro metering pump troubleshooting and installation: resolving loss of prime, vapor lock, check valve fouling, diaphragm weep-hole leaks, and multiplex multi-head flow imbalance on Model D, B, and SDP pumps.

Maintenance

How to Dose PAC: A Step-by-Step Operating Routine for Water Treatment

How to dose PAC in practice: pre-start checks, solution make-up from powder or liquid, settling, priming and calibrating the metering pump, setting the dose from a jar test, shift checks and flushing. A field routine for operators, with safety and anti-crystallization tips.

Maintenance

Dosing Pump Diaphragm Replacement: Step by Step From Pump Head to Test Run

A practical dosing pump diaphragm replacement procedure for mechanical diaphragm metering pumps: isolate and flush, remove the head in a cross pattern, set stroke per the manual, fit the new diaphragm, refit the head the right way up, prime and recalibrate.

Maintenance

Metering Pump Service Life: How Long a Mechanical Diaphragm Pump Really Lasts

Metering pump service life depends less on the pump than on how it is run. Gearbox, motor and housing can last for years, while diaphragms, check valves, O-rings and oil seals are wear parts on a schedule. Here is what shortens a mechanical diaphragm pump's life and how to extend it.

Maintenance

Dosing Pump Foot Valve and Strainer: Why the Suction Sits Off the Tank Bottom

A dosing pump foot valve is a check valve with a strainer on the end of the suction line. The screen stops particles and the ball keeps the line primed when the pump stops. Learn why it should sit above the tank bottom, when to use an inline strainer instead, and signs of a clogged foot valve.

Maintenance

Dosing Pump Bleed Valve: Where It Is and How to Use It

Where is the dosing pump bleed valve? On solenoid pumps it is usually on the pump head next to the discharge valve; mechanical diaphragm pumps need a separate bleed valve on the discharge line near the pump; auto-degassing heads build one in. Learn location, correct use and draining.

Maintenance

Urea Pump Maintenance for SCR and SNCR: Seals, Filters and Shutdown Flushing

A practical urea pump maintenance plan: daily checks, diaphragm, valve and seal intervals, shutdown flushing with demineralized water, strainer cleaning and winter heat tracing checks.

Maintenance

Metering Pump Startup: First Start and Daily Start-Stop Sequence

A field metering pump startup checklist: oil, power, piping and valves before first start, priming at short stroke, then the daily rule of open valves before starting and stop the pump before closing valves.

Maintenance

Metering Pump Calibration: Calibration Column and Bucket Test Methods

Metering pump calibration means measuring real output under real back pressure and correcting the setting. Learn the calibration column method, the bucket test, their errors, and how often to calibrate.

110 items · Page 8 of 11