Zhejiang Weilan Technology Co., Ltd.

Maintenance

Selection guides, maintenance notes and application stories

Maintenance

Dosing Pump Oil Leak: Causes and How to Find Them

Dosing pump oil leak causes explained: worn oil seals, overfilled gearbox, blocked breather, failed housing joints and loose plugs, plus hydraulic diaphragm pump issues and how to tell oil leaks from chemical leaks.

Maintenance

How to Prime a Milton Roy Pump: First Startup and After a Chemical Change

How to prime a Milton Roy pump on first startup or after changing chemicals: pre-start checks, stroke setting, relieving discharge pressure, confirming a full prime, and the flushing step you must not skip.

Maintenance

Milton Roy Pump Oil: Gearbox Lubricant vs Hydraulic Oil

Choosing Milton Roy pump oil starts with the pump type. G Series and MaxRoy need gearbox lubricant only, while Milroyal, Primeroyal and mRoy hydraulic diaphragm pumps also carry hydraulic oil. Learn the ports, grades, levels and seal leak checks.

Maintenance

Milton Roy Pump Troubleshooting: Low Output, Leaks and Noise

Milton Roy pump troubleshooting by symptom: low output, leaks and noise. How to read the fault on G series, MAXROY B, mRoy and Milroyal B pumps before you order parts.

Maintenance

Diaphragm Pump Disassembly: Step-by-Step for Pump Head, Diaphragm and Valves

A field guide to diaphragm pump disassembly on mechanical metering pumps: depressurize and flush, remove lines, head, diaphragm, adapter and oil seal, then check valves, with parts layout tips and reassembly checks based on the NEWDOSE NDJ and ND2000 manual.

Maintenance

Plunger Metering Pump Low Output: Suction, Valves, Packing and Back Pressure

Plunger metering pump low output usually comes down to poor suction conditions, worn check valves, leaking packing, a drifted stroke setting or wrong back pressure. Here is the order to check them, starting with a calibration column test.

Maintenance

Polymer Dosing Pump Calibration: Column Test and Flow Adjustment

How to perform polymer dosing pump calibration accurately: step-by-step drawdown testing with a calibration column using actual PAM solution, avoiding viscosity reading errors, balancing stroke length and frequency, and knowing when to recalibrate.

Maintenance

Polymer Dosing System Operation: Mixing, Aging and Daily Checks

Polymer dosing system operation explained for operators: how an automatic make-down unit cycles on level, what normal looks like at each stage, how to check whether aging time is long enough, and a practical shift and weekly inspection routine.

Maintenance

PAC Dosing System Operating Procedure: Startup, Running and Shutdown

A plant-ready PAC dosing system operating procedure covering pre-start valve and level checks, batch dissolving and mixing, metering pump priming and startup, shift inspection points, clean-water flushing before shutdown, and emergency fault steps.

Maintenance

Chemical Dosing Room Humidity Control: PAC Storage and Corrosion Protection

Practical guide to chemical dosing room humidity control for PAC coagulant rooms: how to store dry bags without caking, vent dissolve tanks, slope floors, size exhaust fans and protect metering pumps and PLC panels from acidic moisture.

110 items · Page 7 of 11