Zhejiang Weilan Technology Co., Ltd.

CNP Nanfang GM & GD Metering Pump: 4-20mA Wiring & Check Valve Maintenance

Author: Zhejiang Weilan Technology Co., Ltd.Source: Official sitePublished: Category: Maintenance
Summary: Comparing CNP Nanfang GM (500 L/h, 12 bar) and GD (135 L/h, 10 bar) mechanical diaphragm metering pumps, plus 4-20mA wiring and check-valve maintenance.

CNP Nanfang metering pumps (GM and GD mechanical diaphragm series) are widely used across municipal water, cooling towers, and wastewater dosing skids. Based on our Nanfang GM and Nanfang GD listings, this guide covers selection, 4–20 mA wiring, and check-valve care.

1. GD vs. GM Series Specs

  1. Nanfang GD Series: Compact double-cam drive, max flow 135 L/h, max pressure 10 bar, 0.2 kW motor.
  2. Nanfang GM Series: Variable-eccentric oil-bath drive, max flow 500 L/h, max pressure 12 bar for heavier continuous duty.

2. How to Wire 4–20 mA Control

Depending on your drive configuration, 4–20 mA wiring follows two paths:

  • Smart Actuator / Digital Controller: Connect PLC/analyzer 4–20 mA leads to AI+ / AI- (4-20mA+ / -) with shielded cable grounded at one end, and switch the menu to AUTO (4 mA = 0%, 20 mA = 100%).
  • 3-Phase VFD Motor: Wire the 4–20 mA signal to the VFD analog current input (AI2 / GND) and verify the VFD current jumper (I) is selected.

3. Check-Valve Cleaning & Reassembly

If the pump runs without discharging liquid, disassemble the suction and discharge check valves separately, clean any chemical scaling from the balls and seats, and reinstall with flow arrows pointing vertically upward and seats below the balls.

4. Oil & Diaphragm Care

For oil-bath GM pumps, replace gearbox oil after the first 500 hours and annually thereafter. Inspect the weep hole regularly for early diaphragm wear.

Conclusion

Correct 4–20 mA wiring and upward check-valve reassembly keep CNP Nanfang GD/GM pumps accurate and reliable. For datasheets or spare parts, contact our team.

FAQ

How do I choose between Nanfang GD and GM?

Use GD for compact skids up to 135 L/h and 10 bar; choose GM for 135–500 L/h, up to 12 bar, and heavy 24/7 duty.

Why doesn't flow change when the 4–20 mA signal changes?

Confirm the controller/VFD is switched from Local/Manual to Auto/Analog mode and verify loop current with a multimeter.

How do I stop chemical siphoning when the pump stops?

Install a backpressure valve on the discharge line and clean or replace fouled check valves.

What is the minimum safe VFD frequency for a metering pump motor?

Keep standard VFD-driven motors at or above 15–20 Hz to maintain cooling airflow unless equipped with a forced-cooling fan.

Should I re-verify flow after replacing the diaphragm?

Yes, run a quick 1-minute drawdown check under operating pressure after any diaphragm or valve rebuild.

Get a Quote

Leave your requirements and we will reply within 1 business day

Inquire Now →