Zhejiang Weilan Technology Co., Ltd.

Maintenance

Selection guides, maintenance notes and application stories

Maintenance

Dosing Pump Pulsation Dampener Installation: Place, Precharge, Vent

Dosing pump pulsation dampener installation fails when the vessel sits far from the pump or precharge is guessed. Follow common drawing practice for orientation, nitrogen fill, venting, and proving the needle calms down.

Maintenance

How to Adjust Dosing Pump Back Pressure Valve Settings

Learn how to adjust dosing pump back pressure valve settings using the discharge gauge, avoid siphoning, and keep relief valve setpoints clear of the back pressure spring.

Maintenance

Solenoid Metering Pump Repair: No Stroke, Alarm Light On, Overheating

A practical solenoid metering pump repair guide covering no stroke, stroking without output, a steady alarm light, overheating, unstable flow and head leaks, with clear checks and fixes for each.

Maintenance

Mechanical Diaphragm Pump Faults: From Leaks to Falling Flow

A practical guide to common mechanical diaphragm pump faults: head leaks, diaphragm rupture, falling flow, no output, low pressure, noise, gearbox oil leaks and motor heat, with causes and fixes.

Maintenance

Integrated Dosing System Troubleshooting: Mixing, Level and Pump Control

Integrated dosing system faults usually sit in mixing, level control, water and powder feed, metering pump interlocks or the controller. Learn how to troubleshoot each stage, including PAM units.

Maintenance

Hydraulic Diaphragm Pump Faults: Refill Valve, Relief Valve and Diaphragm Failure

Most hydraulic diaphragm pump faults trace back to the hydraulic system: a failed refill valve, a relief valve set wrong, air or degraded oil, or a ruptured diaphragm. Learn the symptoms and fixes.

Maintenance

Air in a Dosing Pump: How to Bleed It and Find the Suction Leak

Air in a dosing pump makes it stroke without feeding. Learn how to use the bleed valve correctly, how to find suction-side air leaks, how to handle off-gassing chemicals and how to lay out piping so it stays primed.

Maintenance

Metering Pump Overheating: Motor Overload or Gearbox Oil?

Metering pump overheating usually comes from motor overload, high discharge pressure, low or wrong gearbox oil, worn bearings, poor ventilation or a solenoid pump running flat out. Learn how to check each.

Maintenance

How to Prime a Diaphragm Metering Pump After Startup or a Chemical Change

Priming a diaphragm metering pump after first startup, a chemical change, valve service or a long stop. Step-by-step bleeding for solenoid and motor-driven units, safe settings and how to confirm steady feed.

Maintenance

SEKO Dosing Pump Not Priming? TEKNA Air Bleeding and Mode Checks

SEKO dosing pump not priming? How to bleed air from a TEKNA head, check suction tubing and foot filter, and catch AKS, APG and TPG settings that stop the dosing.

110 items · Page 10 of 11