Zhejiang Weilan Technology Co., Ltd.

Applications

Selection guides, maintenance notes and application stories

Applications

PAC and PAM Ratio: Find It With a Jar Test, Then Tune It on Site

There is no universal PAC and PAM ratio. It falls out of the best dose of each chemical. Learn the two-stage jar test, why the ratio must be calculated on product mass rather than solution volume, and how to set and adjust two metering pumps on site.

Applications

Coagulant Dosing Room Design: PAC Storage, Make-Up and Feed Layout

A practical guide to coagulant dosing room design for PAC: how to lay out storage, solution make-up, day tanks, metering pumps and feed lines in one clean flow, plus floors, drainage, dust control and the mistakes that are hard to fix later.

Applications

Drinking Water Chlorination With Sodium Hypochlorite: Dose, Feed Points and Pump Setup

Drinking water chlorination with sodium hypochlorite starts from the residual you must hold at the plant outlet and at the far end of the network. Learn where hypochlorite is fed in a water plant, how to convert a mg/L dose into pump flow, and how to set up duty and standby metering pumps.

Applications

Raw Water Coagulation With PAC: Adjusting the Dose When River Turbidity Changes

Raw water coagulation on a river intake fails with a fixed PAC setting, because turbidity can rise sharply after rain and fall to cold, clear water in winter. Learn how to build a turbidity versus dose chart from jar tests, pace PAC to flow with turbidity trim and size pumps for the full range.

Applications

Reclaimed Water Disinfection: How to Set the Sodium Hypochlorite Dose

Reclaimed water disinfection with sodium hypochlorite needs far more chlorine than drinking water, because ammonia, organics and solids in treated effluent consume it first. Learn how the dose is built up, how a chlorine demand test sets the starting point, how to size the pump and why residual swings.

Applications

Power Plant Chemical Dosing: How to Configure Each Dosing Unit

Power plant chemical dosing is not one machine but several units: feedwater ammonia, oxygen scavenger, drum phosphate, closed cooling water and circulating water. Learn how to select pumps for each unit, arrange duty and standby, interface with the DCS and what technical specifications often leave out.

Applications

Chemical Dosing System Design for Large Plants: Redundancy, Interlocks and Alarms

Chemical dosing system design for large water and wastewater plants is less about picking a good pump and more about what happens when something fails. Learn how to plan pump and tank redundancy, interlocks, alarm priorities, safe states on signal loss and a manual fallback that keeps dosing running.

Applications

Metering Pump Applications: Where Chemical Dosing Pumps Do the Real Work

Metering pump applications by industry: drinking water, wastewater, boilers, cooling towers, RO, chemical and oil and gas injection, and food CIP. Learn what each plant doses, where it injects, and what to check before you pick a pump.

Applications

Chemical Dosing Room Design for Wastewater Plants: Layout, Ventilation and Safety

What a chemical dosing room does in a wastewater treatment plant, and how to lay it out: segregating incompatible chemicals, pump placement, ventilation by chemical type, secondary containment, eyewash stations and low-level interlocks.

Applications

Chemical Dosing Applications by Industry: Which Chemicals Each Sector Uses

Chemical dosing applications by industry: the chemicals typically dosed in municipal water and wastewater, cooling towers, boilers, RO plants, plating and PCB effluent, food and pharma, and oil and gas, plus how each chemical affects pump and piping choices.

133 items · Page 11 of 14